III-
35
[ 3 ] Installing the Mecha ASSY
(1) Set the two hooks A to the grooves on the under cover of the mecha ASSY.
(2) Fit the hole of the mecha ASSY into the boss on the under cover, and insert the two
hooks B of the mecha ASSY into the holes on the under cover.
(3) Secure the mecha ASSY with the two screws.
Fig.3.2-12 Installing the Mecha ASSY (1)
(4) Put the harnesses of the mecha ASSY through the three holes of the under cover
respectively as shown in the figure.
Fig.3.2-13 Installing the Mecha ASSY (2)
Hooks
Under cover
Flat cable of the head ASSY
Hook B
Hole
Full cutter motor harness
Hole
Screws
Hook A
Hook B
Hook A
Hook A
Mecha ASSY
Under cover
FG harness ASSY
Cutter sensor harness
Rib
Mecha ASSY
Hooks
Tape feed motor ASSY
Hole
Hole
Hole
Hole
Boss
To Next Page
Loading...
