III-
53
[ 12 ] Demonstration Print and Final Check
(1) Insert the AC cord into a outlet.
(2) Set the tape with the maximum width (62mm), and press the Feed button six times in a
row while pressing the ON/OFF button when the power is OFF. Then, leave your fingers
from the both buttons, and 100mm full-width gray print is performed. This print operation
is repeated until the power is turned OFF.
(3) Confirm that the tape is sent properly, print is correct, and the tape is cut properly during
the demonstration print. If you find any problems, consult “CHAPTER IV
TROUGLESHOOTING AND ERROR MESSAGE.”
(4) Open the top cover and confirm that the head ASSY is released from the platen ASSY.
(5) Confirm that the Feed/Cut button works properly.
(6) Confirm that the ON/OFF button works properly.
< Print sample>
To Next Page
Loading...
