Brother VX883 - Straight Stitching; How to Start Sewing

STITCH LENGTH
STITCH WIDTH
NEEDLE POSITION
2
PRESSER FOOT
NEEDLE
PRESSURE ADJUSTER
Straight Stitching
: F-4
: 0
:
M. L. R. (Twin needle sewing, always
set at
M)
: Straight or Zigzag
: Single
: According to the material
HOW TO START SEWING
1. Raise needle to its highest position
and lift presser foot.
2. Pull up lower thread by turning the
balance wheel toward you and place
both upper and lower thread to the
left.
3. Place material under presser foot and
position needle
318 inch (1 cm) from
material edge.
4. Lower presser foot.
5. For reverse sewing, push reverse sewing
button
as far as
it will allow. Reverse
sewing is used where reinforcement is
needed.
6. Release reverse sewlng button and start
sewing in forward direction.
NOTE: Use straight stitch foot when
sewing light or elastic type materials
with straight stitch.
HOW TO CHANGE SEWING DIRECTION
1. Stop machine at the turning point while
the needle is in the material.
2. Raise the presser foot and turn the
material to the new direction while
the needle acts as the axis.
3. Lower the presser foot and start sewing
in new direction.
NOTE: In case of twin needle sewing,
raise the needle at the
turnlng
point.