Brother VX883 - Appliqueing; Cording; Darning

I Appliqueing
I
PATTERN DIAL : 1
STITCH LENGTH : F-2
STITCH WIDTH
: 1-3
PRESSER FOOT
: Zigzag
NEEDLE
: Single
PRESSURE ADJUSTER
: According to the material
1. Baste cut design to the material.
2. Sew carefully following design.
3. Cut away surplus material outside of stitching.
4. Remove basting.
NOTE: Make reinforcement straight stitch at initial
and final sewings.
Cording I
PATTERN DlAL
STlTlCH LENGTH
STITCH WIDTH
PRESSER FOOT
NEEDLE
PRESSURE ADJUSTER
: 1
: F-2
:
In accordance with thickness of cord being
used, set stitch width.
: Zigzag
: Single
: According to the material
1. Set st~tch w~dth dial.
2. Place cord on fabrlc to be sewn.
3. Lower presser foot'maklng sure cord IS centered
and sew
uslng zlgzag st~tch. Gu~de cord by hand to
where you
des~re ~t
/ Darning
PATTERN DIAL
: 1
STITCH LENGTH
: Set at any position
STITCH WIDTH
: 0
PRESSER FOOT
: Straight
NEEDLE PLATE
: Zigzag
NEEDLE
: Single
PRESSURE ADJUSTER
: Up
OTHERS
: Darning plate
1. Place darning plate on needle plate.
2. Place material with area to be darned under presser
foot.
3. Lower presser foot.
4. Stitch by slowly drawing material back and forth.
5. Repeat until area to be darned is completely filled
in.
- 32 -