Brother VX883 - Monogramming and Embroidering

1 Monogramming and Embroidering, Using Embroidery Hoop
PATTERN DIAL
STITCH LENGTH
STITCH WIDTH
PRESSER FOOT
NEEDLE
OTHERS
: 1
: Set at any position
: 0-5
: Removed
: Single
: Darning plate
PREPARATION FOR MONOGRAMMING AND
EMBROIDERING
1. Place darning plate on needle plate.
2. Set your sewing machine as per above instructions.
3. Draw lettering (for monogramming) or design (for
embroidering) on the right side of the material.
4. Stretch work between embroidery hoops as firmly
as possible.
5. Place the work under the needle and lower presser
bar.
6. Pull lower thread up through the work as starting
position by turning balance wheel and make a few
holding stitches.
7. Hold the hoop with thumb and forefingers of both
hands while pressing the material with middle and
third fingers and supporting the outside of hoop
with smaller finger.
MONOGRAMMING
1. Sew, moving hoop slowly along the
lettering at an even rate of speed.
2. Secure with a few straight stitches.
(NOTE: These instructions also apply to
embroidering)
EMBROIDERING
1. Stitch outline of design by moving
embroidery hoop accordingly.
2. Fill in design stitch from outline of
design to inside and from inside to edge
of outline alternately
until1 design is
completely filled in. Keep stitching
close together.
NOTE: A long stitch is made by moving
embroidery hoop rapidly and a
short stitch
is made by moving it
slowly.
I I