Brother VX883 - Operating Your Sewing Machine

I Operating Your Sewing Machine
CONNECTING PLUGS
1. First connect the three-prong plug into
the machine.
2. Then connect the electric supply plug
into a wall outlet.
Caution
When changing needle, bobbin or
light bulb, or when sewing machine is
not in use,
it is recommended that
electrical supply plug is disconnected
to avoid electrical hazards.
Remark:
The illustration on this page depict-
ing the use of two pin plug is not
applicable to use in
U.K.
CONTROLLING SEWING SPEED
Place foot on foot control as shown in
illustration.
When foot control is pushed down lightly,
machine will run at a low speed.
When pressure on foot control is increased,
machine will pick up speed.
When foot control is released, machine will
stop.
NOTE:
1. Care should be taken that nothing is placed on foot controller when machine is not in use.
2. A ney sewing machine or one that has not been in use for a long period of time should
be oiled as per
instruct~on on page 35 & 36. After oiling, be sure to wiper up any excess oil.