Brother VX883 - Check List for Better Sewing

Ieck - . -- List for Better Sewing
Check thls list if you are hav~ng the follow~ng problems:
IF MATERIAL DOES NOT FEED IF UPPER THREAD BREAKS
1. Darning plate is on needle plate. 1. Upper threading IS not correct.
2. Needle plate IS out of position. 2. Needle eye IS not sharp.
3. Stop motion knob is loose. 3. Upper thread 1s too large for needle eye.
4. St~tch length regulator IS at 0. 4. Upper thread tenslon 1s too tlght.
5. Needle 1s Inserted ~ncorrectly.
IF NEEDLE BREAKS
1. Needle is inserted incorrectly.
2. Needle clamp screw 1s loose.
3. Bent needle IS used.
4. Upper threading is not correct.
5. Upper thread tenslon is too tight.
6. Wrong needle and thread for cloth being
sewn are used.
7. Materlal pulled excess~vely.
IF LOOPS FORM ON FABRIC
1. Tens~on of upper or lower thread is wrong.
IF MATERIAL SHOULD PUCKER
1. Thread tension 1s too tlght.
2. Thread~ng is not correct.
3. Thread is caught by something.
4. Lower thread is unevenly wound on
bobbin.
IF LOWER THREAD BREAKS
1. Lower thread 1s entangled In shuttle
2. Lower thread tension IS too tight.
3. Lower threading is not correct.
IF MACHINE SKIPS STiTCHES
1. Needle is not sharp and straight.
2. Needle is inserted ~ncorrectly.
3. Wrong needle and thread for cloth belng
sewn are used.
.4. Upper thread~ng 1s not correct.
5. Lint is cl~nging to under-s~de of needle
plate.
IF MACHINE RUNS HEAVY OR NOISY
1. Machine is out of 011.
2. Lints has accumulated on shuttle and teeth
of feed dog.