231
POWERHEAD
POWERHEAD ASSEMBLY
11
new sleeve o nto the crankshaft u ntil the inst aller
contacts the lower main bearing.
If the inst aller sticks on the sleeve af ter installa-
tion, th read Slide Hamme r, P/N 3910 08, into
installer and pull it off.
IMPORTANT: Inspect sleeve af ter inst allation.
Sleeve must not be used if surface is damaged.
Use retaining ring pliers to install bearing retaining
ring with sharp edge facing away from bearing.
Lubricate a new driveshaft O-ring and lightly lubri-
cate crankshaf t splines with Moly Lube. Inst all
O-ring in sleeve.
Lubricate the center main bea rings and split
sleeves with outboard lubricant and install them in
their original positio ns. The split sleeve ring
grooves must face toward driveshaf t (lower) en d
of crankshaft when installed.
30074
30072
30061
30071
000829
To Next Page
Loading...
