BT BT3110 - Using Additional Handsets; Registering Additional Handsets; De-registering a Handset

37
If you need some help, call us on 0800 145 6789 or go to bt.com/bt3110
Registering an additional handset
If you bought your BT3110 as
a multipack, all the handsets
that came with it will already be
registered to the base.
If you buy new handsets separately,
you’ll need to register them before
you can use them. You can register
up to four handsets.
Once the registration process has
started, you need to complete it
within two minutes. If you run out
of time you can start again.
Tip
You can register up to four GAP
compliant handsets to your BT3110
base to extend your phone system,
without needing to install telephone
extension sockets for each new
phone.
If registration isn’t successful the
rsttime,pleasetryagainincase
the base registration period ran out
of time.
If there are already four handsets
registered to the base, the
registration will fail. You must
de-register another handset before
you can register the new one (see
next page).
Using additional handsets
Please note that registering other
types of handset will only provide
limited compatibility i.e. you may
only be able to make and receive
calls on the additional handset.
At the base:
1.
Press and hold for 5 seconds
until you hear a beep. You now have
90 seconds to register a handset.
At the handset:
2. If the handset isn’t registered to
a base, press
and then enter the
4 digit PIN (default is 0000) and
press
.
Or, if the handset is already
registered to a base, press
and
scroll
to ADVANCED SET and
press
.
3. Press until REGISTER is
displayed. Press
.
4.You’llbeaskedtoconrmyour
PIN. Type in your 4 digit PIN (default
is 0000) and then press
. You
will hear a beep if registration
is successful and the handset is
automatically assigned an available
handset number.
De-registering a handset
You’ll need to use one handset to
de-register another. You can’t
de-register the handset you’re using.