4
Quick set-up guide
Where to put your phone
• Place the base within
2 metres of a mains power
socket and 1.8 metres of a
phone socket so the cables
will reach.
• Make sure it’s at least a
metre away from other
electrical appliances to avoid
interference.
• Don’t place the phone or
base in a bathroom or other
humid area.
• The product works by
sending radio signals between
the handset and base. The
strength of the signal depends
on where you position the
base. Putting it as high as
possible can help give you
the best signal.
1. Plug in
1. Plug the mains power adaptor
into the base, with the cable clipped
in the groove provided.
2.
Plug the other end of the power
adaptor into the wall power socket
and switch on.
The phone line cord is pre-installed
but don’t plug the other end into
the wall socket yet.
Important
• Don’t connect the phone line to
a phone socket until the handset is
fully charged.
• The base station should be
plugged into the mains power socket
all the time.
2
1
To Next Page
Loading...
Need help?
General
