BT BT3920 - Using Additional Handsets; Registering Additional Handsets to the Base

If you need some help, call us on 0800 218 2182* or go to bt.com/producthelp
56
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one, see “Delete
a handset” on page 51
for instructions.
The default 4 digit system
PIN is 0000.
If you enter a digit incorrectly,
select
to delete it.
You have 2 minutes to complete
the registration process.
If registration isn’t successful
the first time, please try again
incase the base registration
period ran out of time.
You can register up to five GAP compliant handsets
to your BT3920 base to extend your phone system
without needing to install telephone extension
sockets for each new phone.
If you’ve bought a BT3920 multiple pack, all
additional handsets come pre-registered to the
base. However, if you purchase an additional
handset separately, you must register it to your
BT3920 base (as shown on Page 6) before it can
be used. If a handset becomes un-registered it will
need to be registered to the base again.
Register an additional handset
1. Select Menu, scroll
Vol.
Calls
or
Vol.
Calls
to Registration and
select
.
2. Scroll
Vol.
Calls
or
Vol.
Calls
to select the base you want and
select .
3. Enter PIN is displayed. Enter the 4 digit system PIN
and select
. The handset will display Please wait .
4. Press and hold the button on the base for
approximately 5 seconds until you hear a long beep
and the green In use light begins to flash.
5. Once registration is successful the handset will
display Handset x (with x being the assigned next
available handset number).
Using additional handsets