Functions and parameters
Parameters
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 6 – 9
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
6.5 Parameters
6.5.1 General
The truck's steering system stores a number of parameters. These
parameters are used to configure the truck for correct operation in
specific settings and for a particular application. The parameters are
divided into three groups:
• Operator parameters – Adapts truck travel performance for a
specific operator or application. Operator parameters can be
changed at any time without a CAN service key.
• Service parameters – Used to adapt functional performance of the
truck. Service parameters can only be adjusted when a suitable
CAN service key is plugged into the truck. Please note that the
service parameters can be checked without any need for plugging in
a CAN service key, however it is not possible to change the values.
• Factory parameters – Parameters pre-set at the factory, which in
case of special requirements can be changed by a service
technician. As an example, these parameters indicate the truck
model and which controls to use for the hydraulic function. The
factory parameters cannot be changed with the CAN service key.
All parameters can be changed via a PC/PDA running TruckCom.
6.5.2 Show parameters
Proceed as follows to only display and verify the various truck settings:
1. Connect the CAN key or enter a PIN code, then press the horn
button and keep it depressed.
The display shows:
- Operating times and time remaining until next service (H)
- Error codes (E).
- Parameters (P).
- Hardware and software numbers (Pn).
- Display test function (d)
- Collision sensor log (c)
- Emergency drive mode (Ed)
- Calibration (CAL). Shortcut for setting parameter 108 = 1
2. Release the horn button when what you wish to view is displayed.
3. To scroll between the settings for each mode above, turn the speed
control.
https://www.besttruckmanuals.com/
To Next Page
Loading...
