8 – 2 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Chassis 0000
Support arm 0350
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
8.1.2 Adjusting the kneeling action
The gap between the chassis pressure plate and the support arm link
roller must be between the minimum value of 0.4 and the maximum of
2.0.
1. Check the gap. A precondition for checking the gap is that the roller
is fitted and that they are in the lowered position.
2. Loosen the cylinder (a) if the gap is incorrect (6 mm Allen)
3. Place a suitable number of shims 7501642 under the cylinder (a).
4. Tighten the cylinder.
5. Check that the gap is correct.
a
https://www.besttruckmanuals.com/
To Next Page
Loading...
