Electrical components
Replacing the wiring harness
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 16 – 1
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
16 – Electrical components
16.1 Replacing the wiring harness
Proceed as follows when replacing the wire harness:
1. When separating X connectors, press in the connector lock (A) to
the female part (B) and pull upwards.
2. Disconnect the female part (B) of the connector from the male part
(D).
3. Then remove the male part (D) by pulling it downwards.
Pos. Description
A Connector lock
B Connector, female part
C Bracket
D Connector, male part
X21
X5
X60
A
B
C
D
https://www.besttruckmanuals.com/
To Next Page
Loading...
