Hydraulic system 6000
Hydraulic unit 6100
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 17 – 5
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
17.3.1 Emptying the hydraulic tank
1. Loosen all cables and tubes to the hydraulic unit.
2. Loosen the hydraulic unit from the truck by releasing the clamps
that surround the pump motor.
3. Loosen the tank from the hydraulic unit by loosening screw (f).
17.3.2 Hydraulic system, bleeding
Cylinders with bleeding valve
1. Loosen all bleeding screws 2 revolutions.
2. Lift slowly at a constant rate until the forks begin to rise (30-40 cm).
3. Close the bleeding screws.
4. Lower the forks and continue to press the lowering button for 10-15
s.
5. Top up with oil.
6. Lift the forks to max.
7. Lower and check the oil level.
Cylinders without bleeding valve
1. Lift slowly at a constant rate until the forks begin to rise.
2. Lower the forks and continue to press the lowering button for 10-15
s.
3. Repeat a couple of times.
4. Top up with oil.
5. Lift the forks to max.
6. Lower to min.
7. Allow to stand approx. 30 min (info for customer).
https://www.besttruckmanuals.com/
To Next Page
Loading...
