Installation
General
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 4 – 1
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
4 – Installation
4.1 General
The chapter describes the work that has to be done before the truck is
put into operation.
4.2 Battery installation
4.2.1 Battery installation safety
Remember the following safety regulations before you begin working
with the battery:
• Gel batteries are only intended for use at room temperature with a
temperature interval of +15 to +30, otherwise there is a great risk
that the battery will be damaged and its lifetime reduced.
• Always use protective equipment to protect the eyes, face and skin
when you are inspecting, handling or filling batteries.
DANGER!
Battery acid causes burns. If your skin or clothing comes into contact
with battery acid, rinse the area immediately with cold water. If your
face or eyes come into contact with battery acid, rinse the area with
cold water and seek immediate medical attention.
• Ensure that there is a shower and an eye bath nearby in case an
accident occurs.
• A battery emits explosive gases. Never use naked flames or
anything else that could cause sparks close to a battery.
• Do not put tools or other metal objects on the battery. This can lead
to a short circuit or explosion.
https://www.besttruckmanuals.com/
To Next Page
Loading...
