4 – 2 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Installation
Battery installation
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
4.2.2 Install battery
The battery that is to be installed in the truck must be of the right size. A
battery that is too small in terms of size and weight can seriously affect
the truck's braking ability and stability when lifting. See the truck's data
plate for correct information about the battery.
1. Lift the battery into place using an approved lifting device and a
suitable battery yoke or lifting straps.
DANGER!
The battery may fall when the lifting device is loosened if it has not
been secured with an axle stand or other similar suspension gear of
the right height. Check the height of your suspension gear before
loosening the lifting yoke.
2. Check the electrolyte level in the battery. This should normally be
10-15 mm above the cell plates.
3. Connect the battery cables/battery sleeve.
DANGER!
Always check that you have the right polarity when connecting the
battery cables. Compare the markings on the cables with the
markings on the battery terminals. A wrongly connected battery may
cause a short circuit.
4. Close the battery lid.
5. Put the battery connector back.
6. Check or enter the parameters for the battery and battery charger.
See the section Adjusting battery and battery charger parameters
in this chapter.
7. Function test the truck before using it.
https://www.besttruckmanuals.com/
To Next Page
Loading...
