Bucher Municipal
V Range
107
JVM
V50 • V65 • V80 Operator’s Guide
Menu 4.10.1.2
Select the Left Hand Cylinder by holding down top Left button on pendant. (Green LED
goes out). Use raise and lower buttons as indicated to archive the required setting.
Releasing the Left hand button returns the screen to 4.10.1.
Press F2 to select LH Slew and repeat process. Pressing F1 exits the menu, and the Wide
Sweep Brush turns o and goes to raised position.
Note:- When adjusting the brush it is not unusual to see the voltage settings dier from
side to side, the values on the screen are used as references to the settings of the
regulators.
Wide Sweep Brush Balance/Adjustment
Brush balance/adjustment should be checked on a regular basis.
On dual sweep machines brush balance/adjustment is necessary for both left and right
hand operations.
The adjustments are used to set the brush pressure on the road and counteract uneven
(conical) brush wear.
When correctly adjusted the brush should leave a parallel witness mark in the region of
75mm wide over the full length of the WSB when it is operated on a at surface with the
vehicle stationary.
To generate a witness mark:
With the vehicle stationary operate WSB on the desired slew for approximately 30
seconds, switch o WSB, move vehicle and examine witness mark left on the road.
If witness mark is too narrow:
Less regulation is required (Adjust down/Brush heavier).
If witness mark is too wide:
More regulation is required (Adjust up/Brush lighter).
Note:
Ensure the pneumatic system is fully pressurised by running the truck engine whilst
carrying out the regulation adjustments.
Correctly adjusted brush leaves a parallel witness mark on road (Nominal 75mm).
Incorrectly adjusted brush leaves wider, narrower, or tapering witness mark on road.
To Next Page
Loading...