Bucher Municipal
V Range
97
JVM
V50 • V65 • V80 Operator’s Guide
J-Plex - The Sweeper Control System
J-Plex II is an electronic road sweeper control system which uses multiplex technology to enable
multiple control signals to be combined into one common signal which can then be transmitted
and received down a pair of wires (serial communication). This eliminates a substantial number of
wires and connections from the vehicle’s electrical system, which in turn reduces the size of wiring
harnesses and increases reliability. Wiring from Input/Output (I/O) devices such as switches or
hydraulic valves is via a local I/O collecting module called a node. On the V50, V65, V80 sweepers,
the J-Plex control system consists of a JVM screen, 2 Key Pad nodes and 3 remote I/O nodes. The
JVM acts as the master control unit and communicates between each external node via a CANbus
control network.
JVM Provides:
The operator interface with the powerful diagnostic features provided by J-Plex.
The ability to check the status of Inputs and Outputs.
Information regarding the machine operating status, fuel tank contents, etc.
Data capture - hours sweeping, distance travelled, etc.
Fully customisable modern sweeping experience.
Clear display showing current operation status.
Direct communication with the Chassis.
Operating Instructions:
Throughout the J-Plex, pictorial icons are used to both confirm the current status and when
required communicate instructions.
(1) Powapak
(2) Subframe
(3) Systems Locker
(4) Centre Console
(5) Door Controller
(6) Wireless Pendant
Node Description
LOCATION OF J-PLEX COMPONENTS
DESCRIPTION
To Next Page
Loading...