Bucher Municipal
V Range
85
Optional Equipment
V50 • V65 • V80 Operator’s Guide
Preparation
When using either the Wanderhose or the Littasnatch the nozzle ducting(s) should be closed to
prevent air passing into the body via the nozzle(s). This is easily effected by not operating either
nozzle.
Operation
1. Unclasp the Wanderhose from the bracket at front of body.
2. Clip on extension hose as required.
Note : If the boom is released from the stowage hook before the extension hose is fitted and
rises out of reach, it can be retrieved with the grab provided.
WANDERHOSE AND LITTASNATCH
Vt - Twin Engine
3. Start auxiliary engine and set throttle as required.
Vh - Single Engine
3. Engage Hydrodrive, set engine speed as required and turn on fan.
4. Lower boom and release from stowage hook.
5. Turn on Wanderhose water injection using tap at the rear of the body.
The hose and boom are spring loaded and can be used to the rear, left or right hand side
of a stationary vehicle with a single operator. With a second operator, the hose can be
used whilst the vehicle is moving slowly. The hose operator should position themselves at
the rear of the vehicle, moving onto the footpath to clean around obstructions as they are
encountered. Additional extensions can be added to the equipment for cleaning deep drains,
gullies and catchpits. The Wanderhose can also be employed effectively on surface flood
water.
Note :
The correct operation of the Wanderhose is achieved by holding the pipe just above the
water or debris being picked up.
Vm - Single Engine
3. Engage Hydrodrive, set engine speed as required and turn on fan.
CAUTION
The use of Needle stick gloves is recommended when working with this equipment.
The use of ear defenders is recommended when working with this equipment.
To Next Page
Loading...