Bucher Municipal
V Range
79
Optional Equipment
V50 • V65 • V80 Operator’s Guide
Special notes for cleaning vehicles with vinyl livery or reflective markings
The Supawash handlance or similar can be used for cleaning areas of the vehicle with vinyl or
reflective markings subject to the following precautions being taken
(A) The spray angle should be maintained between 90 and 75 degrees to the panel
(B) The nozzle distance should be greater than 1 metre minimum from the panel
(C) The spray pattern should be a wide fan pattern
(D) The nozzle pressure should be 80 bar (1000PSI) max
● The water temperature should not exceed 60 ºC
● Do not use acid or solvent cleaning solutions û
Alternative Methods
● Do Clean with a sponge or soft cloth using cold or warm water with a soap or detergent,
followed by a cold water rinse
SUPAWASH
Item Description
WARNING
The use of safety goggles is recommended in case of deflected spray/debris.
NEVER direct a high pressure nozzle at the skin as the fluid may penetrate the
underlying tissue etc. and cause serious injury.
NOTICE
Care MUST be taken not to damage sign written areas when cleaning. See special
notes for cleaning vehicles with vinyl livery below.
ALWAYS keep pressure equipment in good condition and regularly maintained,
particularly at joints and unions.
To Next Page
Loading...