Bucher Municipal
V Range
Operation
53
V50 • V65 • V80 Operator’s Guide
Vt
Start chassis engine
The JVM will power up.
Ensure the low air pressure warning lamp and buzzer are off.
Switch ignition ‘On’
Activate using button (A) JVM displays ‘Ignition page’
Water Tank Level - Engine RPM - Fuel Tank Level
Start auxiliary engine using button (B).
Increase engine speed up to 1200 rev/min using button (G) on the Door Controller.
COMMENCE SWEEPING
Selecting the hand of sweep, using button (C).
The equipment specification has been factory set within the JVM.
Dual sweep machines without Simultaneous sweep option.
The equipment can only be set to operate on either the Left or Right hand side.
The selected hand of sweep is indicated by the illumination of the switch located on the centre
console. To change the hand of sweep select the side that is not illuminated.
Dual sweep machines featuring Simultaneous sweeping option.
For Single Sweep Operation: The equipment can be set to operate on either side ie: Left or Right
hand. To change the hand of sweep first select the side that is not illuminated before de-selecting
the other side.
For Simultaneous Sweep Operation:
Select the side that is not illuminated, both sides will now be illuminated indicating the
Simultaneous sweep mode.
Activating the Sweeping Equipment using the Door Controller:
Pressing the corresponding symbol activates the equipment to its sweeping position, the symbol is
displayed on the JVM. The top of the switch activates the corresponding water jets.
Gutter Sprays.
Pressing the switch activates the corresponding gutter spray.
Commence Sweeping:
Select the lowest gear to give a road speed between 2-8 mph (2 to 12 km/h).
Always use the slowest brush and engine speeds consistent with satisfactory cleaning.
Normal engine operating speeds between 1200 - 1500 rev/min.
Eco Mode (D)
Enables the auxiliary engine speed to be operated between idle and 1400 rev/min. Ideal for regular
sweeping whilst maximising fuel economy and minimising noise and emissions.
Eco Mode Override (E)
Enables the auxiliary engine speed to be increase to a maximum of 1750 rev/min for heavy
sweeping conditions.
Boost Mode (Option) (F)
Enables the auxiliary engine speed to be increase to a maximum of 2000 rev/min when particularly
arduous sweeping conditions are encountered.
VEHICLE START UP
To Next Page
Loading...