Bucher Municipal
V Range
Operation
60
V50 • V65 • V80 Operator’s Guide
To avoid the possibility of frost damage to the water system when the machine is left during cold
weather, it is essential to drain the system adequately. In order to assist this process the machine
is equipped with an automated Pressadrain feature. This feature is accessed via the JVM menu
following the on screen instructions the system will automatically purge the water system with air,
displacing any surplus water.
1. Drain the water tank. Running Supawash and Low pressure water will quicken the draining
process
2. Close the Supawash taps, Wanderhose/Littasnatch water taps (if fitted), and water tank drain
taps. Open additional water/line cleaning jet taps on the nozzle (if fitted).
3. Start the Chassis engine.
Using JVM
Select Main Menu (4)
Select Service Menu (11)
Select Pressadrain Menu (5)
4. Follow the on screen instructions.
5. Run the electronic water valve purge. Ensure air pressure rebuilds if the low air warning light
comes on.
6. Run the manual water taps purge.
7. Operate the hand lance, Supawash taps, and Wanderhose/Littasnatch water taps one at a
time for 5-10 seconds each.
8. Turn off manual tap water tap purge.
9. Open the water tank drains again to drain any additional water that has collected and empty
the secondary water filter by removing the red drain plug. Refit the drain plug.
END OF DAY CLEANING
COLD WEATHER PRECAUTIONS
Pressadrain
Recommendations
After washing the machine out it is recommended to leave the rear door slightly open to enable
any moisture to escape and prolong the life of the rear door seal.
NOTICE
The machine is designed for operating between -15°C and 46°C.
CAUTION
After the load has been discharged, lower the body to rest on the prop
A warning light on the JVM illuminates and a audible warning will sound when the
body is not fully lowered or the rear door is not closed correctly
Do not direct high pressure washdown equipment, directly onto the engine, or ancil-
lary electronic or electrical control systems, care should also be taken when washing
the paintwork.
The use of Needle stick gloves is recommended when working with this equipment
To Next Page
Loading...