Bucher Municipal
V Range
77
Optional Equipment
V50 • V65 • V80 Operator’s Guide
SIDE SLIDING BRUSH
Operation
Start the auxiliary engine and set to 1200rpm.
Activating switch (A) rotates the brush and illuminates the ‘Mode’ switch (B), indicating
that the joystick can be used to control the lateral position In/Out of the brush.
Activating switch (C) lowers the brush.
When the ‘Mode’ switch (B) is not illuminated then the joystick controls the Channel
Brush features as standard.
The ‘Mode’ switch (B) can be activated independently allowing the brush to be
positioned over a kerb before lowering.
With the ‘Mode’ switch (B) active the ‘Brush Speed’ is controlled using the switches
(E).
Activating switch (D) activates the water.
Activating the ‘Pause’ switch (F) stops and stows the brush, plus any other sweepgear
that might be in use de-activating it restarts and lowers the brush but it must be moved
out to the work position using joystick.
Turning the in cab Powasave regulator (G) clockwise reduces the ground pressure of
the brush.
Note:
The external regulator sets the maximum ground pressure, this should be set with the
internal regulator fully anti-clockwise.
Adjustments
Brush Settings (with Rotatilt)
With the ‘Mode’ switch (B) illuminated move the brush out to the desired position using
the door mounted joystick.
Left = Out - Right = In.
Press and hold the top button (H) together with the in/out function to change the
brush head camber (I).
. Press and hold the top button (H) together with forward/backward function to change
the brush head tilt angle (J).
Note:
As detailed above, the brush angle to the ground is set using the cab control joystick.
Approximately 120
o
of the circumference of the brush (towards the front and kerbside)
should be in contact with the road.
To Next Page
Loading...