Bucher Municipal
V Range
75
Optional Equipment
V50 • V65 • V80 Operator’s Guide
The angle of the channel brush can be adjusted from the cab when sweeping.
Operation
Operating the Joystick left/right together with the button on the top positions the Prime-side
Rotatilt.
Operating the Joystick left/right together with the button on the top and the end positions
the non Prime-side Rotatilt.
A push button (A) is fitted on the nearside at the rear of the body. The auxiliary engine should be
set at tickover, or stopped, and with the main engine running press the button for 10 seconds.
Repeat this process two times.
REAR MESH SHAKER
ROTATILT
Powathrust Operation
P-12V2
The channel brush Powathrust regulator located in the systems locker, is pre-set at 3.5
bar, and provides a means to increase the ground pressure of the brush on the road. The
regulator sets the maximum pressure.
The switch located on the door control turns the Powathrust ON/OFF.
With Powathrust active the ground pressure is adjusted using the in cab Powasave regulator.
POWATHRUST & POWASCRUB
Powascrub Operation
P-18V1
The wide sweep brush Powascrub regulator located in the systems locker, is pre-set at 2
bar, and provides a means to increase the ground pressure of the brush on the road. The
regulator sets the maximum pressure.
The switch located on the door control turns the Powascrub ON/OFF.
With Powascrub active the ground pressure is adjusted using the in cab Powascrub
regulator.
Note:
The Rotatilt will only function when channel brush is operating.
When stowing the channel brush, ensure the brush angle is reduced so that the brush stock
does not protrude beyond the vehicle width.
A rotary switch (B) is fitted on the nearside at the rear of the body. The hopper meshes can be
lowered and lifted into place remotely, therefore avoiding the dirty zone when tipping and cleaning.
REMOTE MESH RAISE/LOWER
To Next Page
Loading...