Bucher Municipal
V Range
Routine Maintenance
151
V50 • V65 • V80 Operator’s Guide
Air Cleaner Restriction Indicator
A filter condition is electronically monitored and when restricted the icon is displayed on the
JVM, giving a positive indication of when the air cleaner element needs replacing and so
eliminates haphazard servicing. It should be attended to immediately.
Note:
The indicator does not show the amount of dust present in the dust cap. When the air
cleaner requires servicing the warning icon will be illuminated. After servicing the indicator
will automatically reset.
Air Cleaner
The air cleaner elements must be replaced at the intervals given in the Maintenance Schedule
or if the filter restriction indicator is showing red between these scheduled services.
Cylinder Maintenance
Periodically inspect the cylinder rods for damage, blemishes or build up of material such
as tar, cement, paint etc. Particular attention should be given to the wide sweep brush
slew cylinder on dual sweep machines and the channel brush lift cylinder. The rods can
be cleaned with fine wire wool and/or spirit to ensure long seal life. When cleaning the
machine avoid playing the washdown hose over the body tip cylinder when in the fully raised
condition.
Vt - Twin Engine
To access the air cleaner elements, lift the retaining clips (A) to remove the lid (B). Remove
the main filter element (C) by first pushing the filter down and tilting it towards the radiator
and then lift it out *. There is a small safety element (D) within the main filter body, this should
be replaced every third time the main element is changed. Re-assemble the air cleaner
ensuring all parts are correctly positioned and fitted. Refit the lid (A) ensuring a good seal
against water ingress.
(*) JCB 85kW.
NOTICE
Ensure that the elements, lid and clips are correctly fitted and that the air intake pipe
and clips to the engine are in good condition and fully sealed.
To Next Page
Loading...