Buchi V-600 - Cleaning the Diaphragm; Servicing; Notes on Servicing

7 | Cleaning and servicing BÜCHI Labortechnik AG
42/65 Operation Manual Vacuum Pump V-600
u Refit the pump-head connecting tube (see Chapter7.2.5 "Replacing connecting
tubes", page50).
u Refit the casing front.
u Switch on the pump and allow it to run in continuous mode until the inside of the
tubing is dried out.
7.1.6 Cleaning the diaphragm
u Remove the diaphragm, see Replacing the diaphragm.
u Clean the diaphragm with a cloth and a little acetone.
7.2 Servicing
7.2.1 Notes on servicing
WARNING
Risk of fatal injury from electric shock.
If the pump is opened up while it is running there is a risk of dangerous electric
shocks.
u Before carrying out any cleaning or servicing work, always shut down the device
and disconnect the power cable.
IMPORTANT
Risk of pump damage and loss of warranty entitlement.
Unauthorized opening up of any casing components apart from the casing front may
permanently impair the function of the pump.
u Only allow authorized BUCHI service technicians to open up the rear part of the
pump.