Buderus Logamatic EMS RC35 Installation And Service Instructions

Logamatic EMS RC35 programming unit - Subject to technical modifications
23
System settings (Service menu – Settings)
6
6 System settings (Service menu – Settings)
B Press + + simultaneously to open the SERVICE MENU.
B Turn rotary selector anti-clockwise, until settings is selected.
B Press to open menu SERVICE\SETTINGS.
6.1 Plant data
B Press to select plant data.
The menu SETTINGS\SYSTEM opens.
Note that the menu items shown will vary depending on the heating system.
Menu item
Input
range
Factory
setting
Other information
Which language should be used? English, ... Francais
Have you installed a module for
the hydraulic separator?
yes, no no In conjunction with MCM10, this
setting is automatically set to “yes”;
the mask is hidden.
1)2)
Is a sensor for a low loss header
connected?
no,
at the
boiler,
at the low
loss header
module
no When a low loss header is used,
connect the temperature sensor to
the low loss header module.
3)
Is heating circuit 1 installed
(unmixed heating circuit)?
yes, no yes
How many mixed heating circuits
are installed?
0 to 3 0 Set the address at the rotary coding
switch on the mixer module (factory
setting HC2).
1)
Have you installed a solar
module?
yes, no no
1)
Tab. 9 Navigator for service menu SETTINGS\SYSTEM
SERVICE MENU
quick operation
settings
diagnosis
servicing
B
SERVICE\SETTINGS
B plant data
boiler data
domestic hot water
heating circuit 1

Buderus Logamatic EMS RC35 Specifications

General

Brand	Buderus
Model	Logamatic EMS RC35
Category	Controller
Language	English