Logamatic EMS RC35 programming unit - Subject to technical modifications
7
Product information
2
2 Product information
2.1 Correct use
The RC35 programming unit must only be used to operate and control Buderus heating systems.
B Always use this appliance correctly and in conjunction with the specified control systems.
B Observe all regulations and standards applicable to the installation and operation of the system
in your country!
The boiler must be equipped with EMS (energy management system) or UBA1.x (universal burner
controller).
Never operate the programming unit with the control units of the Logamatic 2000/4000 series.
We recommend always operating the heating system with the programming unit (only emergency
operation possible without programming unit).
If using remote control units RC2x produced before or in 2005, only two remote control units can
be connected. In case of related questions, please contact your local Buderus sales office.
These instructions describe all possible functions of the RC35 programming unit. Some of these
functions may not be available, depending on which boiler (combustion controller) is used. You will
find information on this in the relevant chapter.
For information regarding the combustion controller, see menu DIAGNOSIS\VERSIONS
(Æ page 45).
2.2 EU Declaration of Conformity
The design and operation of this product conform to the European Directives and the supplementary
national requirements. Its conformity is demonstrated by the CE designation. You can call up the
Declaration of Conformity for this product on the internet at www.buderus.de/konfo or request it
from your local Buderus sales office.
2.3 Standard delivery
• RC35 programming unit
• Operating instructions
• Installation and service instructions
• Wall mounting base, mounting materials
To Next Page
Loading...
Need help?
General
