Buderus Logamatic EMS RC35 Installation And Service Instructions

Logamatic EMS RC35 programming unit - Subject to technical modifications
17
Principles of operation
4
4.3 Overview of the service menu
The SERVICE MENU is divided into the following menus and submenus:
Menu Submenu Contents/function Page
quick operation The most important parameters from the
“settings” menu to configure the heating system
20
settings
(all parameters)
plant data
1)
1) Limited use depending on the boiler used.
Parameters: language, number of heating
circuits, installed modules, building type,
minimum outside temperature
23
boiler data
1)2)
2) May not be available or possible, depending on the boiler used.
Parameters: pump run-on time and modulation 26
heating circuit data
1)
Parameters of the installed heating circuits 27
domestic hot water
1)
Parameters for domestic hot water 36
solar data
2)
If solar is installed: see documentation for the
solar module
39
RC35 calibration Parameters: calibration of the displayed room
temperature
40
contact data Entering the heating contractor's name and
telephone number
41
diagnosis function test
1)2)
Activating individual components for test
purposes
42
monitor value Viewing target values and actual values 43
error message
1)
Viewing error messages 44
htg. charact. curve Viewing the set heating curve in the form of a
graph
45
versions Viewing software versions 45
servicing
1)2)
service interval Setting times for maintenance, by hours run or
by date
46
current messages Viewing service messages 46
RESET servicing Resetting service messages 46
Reset
1)
factory setting Resetting all parameters to their factory settings 47
error list 47
service message 47
operating hours 47
Tab. 5 Service menu navigator

Buderus Logamatic EMS RC35 Specifications

General

Brand	Buderus
Model	Logamatic EMS RC35
Category	Controller
Language	English