2-2 2005 Buell Firebolt: Chassis
HOME
TORQUE VALUES
ITEM TORQUE NOTES
Airbox cover fasteners 12-36
in-lbs
1-4 Nm page 2-88
Airhorn fastener 72-96
in-lbs
8-10 Nm page 2-74
Axle pinch fastener, rear 40-45 ft-lbs 54-61 Nm page 2-18
Axle pinch fasteners, front 20-22 ft-lbs 27-30 Nm page 2-15
Axle, front 39-41 ft-lbs 53-56 Nm ANTI-SIEZE, Left handed thread, page 2-15
Axle, rear ANTI-SEIZE
Follow special
instructions,
page 2-18
Bank angle sensor 12-36
in-lbs
1-4 Nm page 2-72
Brake hand lever housing fas-
teners
80-90
in-lbs
9-10 Nm page 2-29
Brake lamp switch fastener,
front
7-10
in-lbs
0.8-1.0 Nm page 2-29
Brake line p-clamp fastener,
front
36-60
in-lbs
4-7 Nm page 2-31
Brake line p-clamp fastener,
rear
36-60
in-lbs
4-7 Nm page 2-40
Brake pedal fastener 22-24 ft-lbs 30-33 Nm LOCTITE 272, page 2-25
Brake pin hanger set, front 11-14 ft-lbs 15-19 Nm page 2-33
Brake pin hanger set, rear 11-14 ft-lbs 15-20 Nm page 2-42
Brake pin plug, rear 22-26
in-lbs
2-3 Nm page 2-42
Brake reservoir fastener, rear 96-120
in-lbs
11-14 Nm page 2-92
Caliper banjo bolt, front 16-20 ft-lbs 22-27 Nm metric, page 2-31
Caliper banjo bolt, rear 16-20 ft-lbs 22-27 Nm page 2-40
Caliper bleeder valves 36-60
in-lbs
4-7 Nm metric, page 2-26
Caliper carrier, rear 24-26 ft-lbs 32-35 Nm page 2-19
Caliper fasteners, front 15-19 ft-lbs 20-26 Nm page 2-33
Caliper mounting fasteners,
front
35-37 ft-lbs 47-50 Nm page 2-33
Caliper mounting large fas-
tener, rear
18-21 ft-lbs 24-28 Nm page 2-43
Caliper mounting small fas-
tener, rear
14-18 ft-lbs 19-24 Nm page 2-43
Chin fairing fasteners 36-48
in-lbs
4-5 Nm page 2-87
Clutch cable p-clamp 12-36
in-lbs
1-4 Nm page 2-62
Clutch inspection cover fas-
teners
84-108
in-lbs
9.5-12.2 Nm Tighten in a crosswise pattern, page 2-70
Electronic control module fas-
teners
72-96
in-lbs
8-11 Nm page 2-73
Engine shroud air scoop 12-36
in-lbs
1-4 Nm page 2-89
Exhaust header mounting nut 72-96
in-lbs
8-11 Nm page 2-80
To Next Page
Loading...
