Buell P3 2003 - Page 348

2003 Buell P3: Electrical 7-9
HOME
Figure 7-7. Continuous or No Spark At Spark Plug
YES
NO
Is Bank Angle Sensor Connected?
Reconnect.
Disconnect Connector [134].
Measure Voltage On [134B] Between Socket A, LT GN/GY And Socket B, BK
3.0-3.5 VDC 11-13 VDC 0 VDC
See Next Page
Repair Short On
LT GN/GY Wire.
5007
YES
NO
Repair Open In
LT GN/GY Wire.
5007
Disconnect Connector [10]. Check Continuity Between Socket A, LT GN/GY
On Connector [134B] And Socket 5, LT GN/GY On Connector [10B].
Continuity Present?
YES
NO
Check Starter
Interlock.
Check Continuity To Ground On LT GN/GY Wire, Socket A,
Connector [134B] Or [10B].
Is Continuity Present?
5007
Check Continuity To Ground On TN/Y Wire, Socket B,
Connector [134B].
Is Continuity Present?
YES
NO
Inspect Module Harness For Damage.
Repair If Necessary.
If Harness Is Not Damaged, Replace
Ignition Module.
5009
Repair Short To Ground On LT
GN/GY Wire.
5007
* To avoid damage to terminals, remove
Bank Angle Sensor before disconnecting
connector [134]. Use Harness Connector
Adapter Kit HD-41404,Gray male probe
and patch cord
Bank Angle Sensor
Connector [134]
8261