2003 Buell P3: Maintenance 1-19
HOME
TRANSMISSION/PRIMARY FLUID 1.10
GENERAL
The transmission should be drained and refilled with fresh
fluid:
● At the 1000 mile (1600 km) initial service and at every
5000 (8000 km) service interval thereafter.
Transmission fluid capacity is 1.0 quart (0.95 liter). For best
results, drain fluid while it is hot.
INSPECTION
1. Remove seat. See 2.28 SEAT.
11WARNING1WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before pro-
ceeding. Inadequate safety precautions could result in
death or serious injury.
2. Disconnect negative battery cable from battery.
3. Remove left footpeg support bracket. See 2.21 FOOT-
PEGS AND FOOTPEG SUPPORT BRACKETS.
4. See Figure 1-15. Remove three TORX screws with
washers (1) from clutch inspection cover (2). Remove
clutch inspection cover from primary cover.
5. See Figure 1-16. Inspect fluid level with motorcycle in
upright position.
6. See Figure 1-15. Install clutch inspection cover using
three TORX screws with washers. Tighten in a crosswise
pattern to 84-108 in-lbs (9.5-12.2 Nm).
7. Install left footpeg support bracket. See 2.21 FOOT-
PEGS AND FOOTPEG SUPPORT BRACKETS.
8. Connect negative battery cable to battery. See 1.4 BAT-
TERY.
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
9. Install seat. See 2.28 SEAT.
Figure 1-15. Primary Cover
7667
1. Torx screws with washers (3)
2. Clutch inspection cover
3. Magnetic drain plug (with o-ring)
1
2
3
Figure 1-16. Fluid Level
1. Adjusting screw
2. Cable end
3. Coupling
4. Correct fluid level
a0126x6x
1
4
3
2
To Next Page
Loading...
