What to do if the current output transmits a value between 22 and 30 mA from Burkert Accessories?
If the current output transmits a value between 22 and 30 mA, switch the device power supply off and then on. If the problem occurs again, take contact with the retailer.
What to do if the current output transmits a value > 30 mA from Burkert Accessories?
If the current output transmits a value greater than 30 mA, check the wiring of the current output. If the problem persists, contact the retailer.
What to do if the displayed flow rate is always nil in Burkert Accessories?
If the displayed flow rate is always nil, verify that the flow rate in the pipe isn't nil. Also, check that the K factor or the Kw coefficient aren't too low, ensure the electrodes are perpendicular to the flow direction. Try choosing a smaller flow rate unit or increasing the number of displayed decimals.
What to do if the current output transmits 4 mA whatever the displayed flow rate value from Burkert Accessories?
Check the configuration of the current output.
What to do if the current output transmits 20 mA whatever the displayed flow rate value from Burkert Accessories?
Check the configuration of the current output.
What to do if the current value transmitted on the AO1 current output does not correspond to the displayed flow rate for Burkert Accessories?
Check the configuration of the current output and verify the OFFSET and SPAN parameters of the current output.
General| Model | 8045 |
|---|---|
| Device Type | Transmitter |
| Measurement Principle | Electromagnetic |
| Output Signal | 4-20 mA |
| Material | Stainless steel |
| Lining Material Options | PTFE |
| Electrode Material Options | Stainless Steel, Hastelloy |
| Accuracy | ±0.5% |
| Ambient Temperature Range | -20 to 60 °C |
| Protection Rating | IP65 |
| Certifications | ATEX |
Explains warning symbols and icons used in the manual for safety and information.
Clarifies that the term "device" in this manual refers specifically to the flowmeter type 8045.
Specifies the intended use of the 8045 flowmeter for measuring liquid flow rates.
Describes the flowmeter's components, operation principle, and power supply requirements.
Lists the different versions of the 8045 flowmeter and their key specifications.
Specifies ambient conditions, humidity, altitude, and protection class for device operation.
Details the mechanical components and materials used in the flowmeter construction.
Outlines power supply, current consumption, and output specifications for the device.
Provides critical safety warnings and precautions for installation and commissioning.
Details procedures for mounting the flowmeter onto a pipe, including fitting recommendations.
Explains the electrical wiring connections and procedures for the device.
Important safety warnings related to the device's operation and handling.
Describes the Process and Configuration levels for device interaction and settings.
Explains the function of device buttons and status indicators for user interaction.
Overview of configurable parameters and how to access and adjust them.
How to select the preferred language for the device display interface.
Detailed steps for setting up the 4-20 mA analog output for flow rate measurement.
Setting DO1 to switch based on upper/lower flow rate thresholds for control or alarms.
Setting up the digital input to trigger specific device functions remotely.
Overview of diagnostic tests and calibration procedures available for the device.
Calibrating the 4-20 mA output offset and span for improved measurement accuracy.
Procedure to set the zero point for accurate flow measurements, especially after maintenance.
Critical safety warnings specific to maintenance activities and troubleshooting procedures.
Guidelines for safely cleaning the flow sensor components to maintain performance.
Comprehensive guide to resolving common issues, error messages, and LED indicators.
Troubleshooting steps for issues when the device status LED is off.
Troubleshooting steps for red LED status without explicit error messages.
Troubleshooting steps for orange LED status without explicit error messages.
Lists available spare parts, accessories, and their corresponding order codes.
To Next Page
