2. Navigate to the Alarms folder and then enter the Alarm folder that you require (Alarm
A, B, C).
3. Set Type to Alarm.
4. Set the source for the Alarm. For a detailed description consult the parametric guide
section on Alarms.
5. Set the Threshold for the selected fail condition.
6. Set the Pin Polarity
7. Set the On Delay
8. Set the Off Delay
9. If an e-mail notification is required, set Send e-mail to Yes. Make sure that e-mails are
set up correctly.
To set up an Alarm pin as Analog Output:
1. Connect the required alarm pin to the external measuring equipment. Observe correct
current and voltage ratings. Note that an external pull-up resistor may be required.
2. Navigate to the Alarms folder and enter the Alarm folder that you require (Alarm A, B,
C, ..).
3. Set Type to Analog Out.
4. Set the Source for the Analog Out. For a detailed description consult the parametric
guide section on Alarms.
7.5 System
7.5.1 Real Time Clock
1. Set the Date (day Month Year)
2. Set the Time (hh:mm:ss). It is important to set up the clock and date for support diagnos-
tics.
7.5.2 Unit Information
1. Set Location (a brief description of the physical location of the device)
2. Set Contact (Name of the person who manages the unit)
35
To Next Page
Loading...
