Password
This is the password for the remote login. It accepts text of up to 15 characters
8.5.10 Ethernet
The V2 Transmitters have a built in web server which can monitor and control all transmitter
parameters remotely without the need to install any software. The unit can use either static
or dynamic IP addressing. All Ethernet parameters are set in this folder.
Ethernet Parameters:
DHCP
Sets whether the Ethernet is configured manually or by DHCP.
Parameters when DHCP is on:
A DHCP IP This read only parameter shows the IP given by the DHCP to the unit.
B DHCP SM This read only parameter shows the DHCP subnet mask.
C DHCP GW This read only parameter shows the DHCP gateway
D DHCP DNS 1 This read only parameter shows the DHCP Primary DNS server.
E DHCP DNS 2 This read only parameter shows the DHCP Secondary server.
F MAC This read only parameter shows the Ethernet MAC address.
Parameters when DHCP is off:
A Static IP Sets the manual IP address. Accepts an IPv4 address in the form
aaa.bbb.ccc.ddd
B Static SM Sets the manual subnet mask. Accepts an IPV4 address in the form
aaa.bbb.ccc.ddd
C Static GW Sets the manual gateway. Accepts an IPV4 address in the form
aaa.bbb.ccc.ddd
D Static DNS1 Sets the manual Primary DNS server. Accepts an IPv4 address in the form
aaa.bbb.ccc.ddd
E Static DNS2 Sets the manual Secondary DNS server. Accepts an IPv4 address in the form
aaa.bbb.ccc.ddd
F MAC This read only parameter shows the Ethernet MAC address.
72
To Next Page
Loading...
