Enable
Enables/disables the telnet server.
Port
Sets the telnet TCP port. Telnet must be set to Disabled to change. This parameter accepts
values from 1 to 1024.
8.5.14 RS232
Enable
Enables/disables the RS232 remote.
Baud Rate
Sets the RS232 baud rate.
8.5.15 Log
V2 Transmitters have three methods of logging, regardless of the log location, the format is
the same. V2 Transmitters will output a list of important parameters, all meter settings and
alarm and trigger statuses 2 minutes after a parameter change and then at hourly intervals.
These can be either received via RS232, UDP or saved to a file on the device. Each method
can be enabled or disabled.
RS232
Enables/disables logging to RS232.
File
Enables/disables logging to file.
75
To Next Page
Loading...
