7.5.11 Diagnostics
This set of parameters report the state of various parts of the system upon boot (OK or fail). If
an error condition is observed, the unit should be re-booted and these parameters should be
examined. This information will be useful when contacting support.
7.5.12 About
The about menu contains the version numbers of the different parts of the system. These val-
ues should be available when contacting support.
7.5.13 Reboot
This parameter will reboot the unit.
7.5.14 Factory Reset
Performs a factory reset, setting all the parameters to its default value except for Network set-
tings. All user changes will be lost.
7.6 Web Remote
V2 Transmitters provide a graphical web based interface for ease of use and control. This
can be accessed by navigating to the IP address of the unit in any standard web browser.
After entering the login details for the unit, the user can then read and write all parameters
and also perform firmware upgrades. All parameters are saved and updated dynamically
as they are changed in the remote. The system serves a mobile-optimised version when ac-
cessed from a mobile web browser.
7.6.1 Autentication
Browse to the IP of the unit (Navigate to System ⇒ Ethernet in the FP. Refer to the Ethernet
section in this manual to set up Ethernet). You will be required to authenticate by entering the
password. This password must match the one selected in the FP (System ⇒ Users ⇒ Pass-
word). The default password is ”pass”.
41
To Next Page
Loading...
