G Disconnect
Clicking this button closes the active web remote session.
H Transmitter Controls
All the controls in the transmitter can be found in this section. These are the same op-
tions that can be found in the Front Panel Controll System on the transmitter itself. Click
on the Help Icon (?) located on the top left of the screen or refer to the relevant sections
of this manual to understand any particular feature.
I TX Model and Serial Number Indicator
The TX Model and product Serial Number are displayed on the top right of the page.
7.7 Text Based Access (Telnet or Serial RS232)
The unit offers text based access via a local network or the internet through Telnet or serial
RS232.
7.7.1 Commands
The following commands are available:
Command Description
help Displays help message
get Gets a parameter
set Sets a parameter
reboot Reboots the unit
factoryReset Restores all settings to factory default except for Ethernet settings
help
This command (without any arguments) displays a list of the commands the unit understands.
help parameter_id This command displays a short description of the requested parameter.
e.g.:
”TX V2> help transmitter.power
transmitter.power: Sets the output power level in watts. This parameter accepts values from
0 to 600.”
44
To Next Page
Loading...
