16 — Ma c h i n i s t ca l c ™ Pr o
+
FRAC COnST
+
(repeats options) FRAC Std.
S
:
(Mathematical Operation) MATH OrDEr
+
MATH CHAIn
+
(repeats options) MATH OrDEr
ENTErINg DImENSIONS
Note: Unlike other Calculated Industries/Construction Master
calculators, the does not have a dedicated Feet key.
Feet is a secondary function located above the
7
key, so you have to
use the
g
key, then
7
to enter or calculate dimensions using Feet.
Below are some examples.
Enter 2 Feet, then label as square and cubic units:
DIMENSIONS KEYSTROKE DISPLAY
2g7
2 FEET
g7
2 SQ FEET
g7
2 CU FEET
Enter 2 Feet, 3 Inches:
KEYSTROKE DISPLAY
2g73i
2 FEET 3 INCH
Linear Dimensions
O
after each entry):
DIMENSIONS KEYSTROKE
23B
4.5 Inches
4.5i
95 millimeters
95m
1320g7
201 meters
201g9
KEYSTROKE DISPLAY
(cont’d)
To Next Page
Loading...
