6 — Ma c h i n i s t ca l c ™ Pr o
gM
M- —
Memory.
Dimensional Function Keys
m
Millimeters —
repeated presses toggling between linear, area and
millimeters, with repeated presses toggling between
millimeters and meters.
g5
Centimeters (cm) —
centimeters, with repeated presses toggling
between linear, area and volume units.
g9
Meters (m) —
repeated presses toggling between linear, area and
volume units.
g7
Feet —
presses of
g 7
toggling between linear, area and
volume units. Also used with
i
and
/
for entering
g 7
during
i
Inch —
presses toggling between linear, area and volume
units. Entry can be whole or decimal numbers. Also
used with
/
for entering fractional Inch values (e.g.,
9i1/2
). Repeated presses during conversions
toggle between fractional and decimal Inches.
/
Fraction Bar —
not entered, the calculator’s fractional accuracy
setting is automatically used. Results are always
shown in typical dimensional fractional format.
(cont’d)
To Next Page
Loading...
