Us e r 's GU i d e — 41
t
after entering it in order
Thread Size TPI/Pitch
8, 10, 12, 14
less than 100
less than 100
Metric
Note: Entries outside of the ranges mentioned above will result in an
Entry Error.
The following tables list the available Thread characteristics
Thread
Classication section).
Internal Thread
* If the resulting hole size is greater than 2 Inches or 50 mm, the actual
hole size will be displayed instead of adjusting to the closest Drill Size.
(cont’d)
To Next Page
Loading...
Need help?
General
