52 — Ma c h i n i s t ca l c ™ Pr o
6. Find the Pitch Diameter:
R P-DIA
SIZE 0.3316 INCH
R WIRE
SIZE
$
0.04 INCH
* If no Wire Size is entered, the calculated Ideal Wire Size will be used
to nd the Pitch Diameter.
BOlT PaTTErN
With the Machinist Calc Pro
center spacing (i.e. on-center distance from hole to hole).
Bolt Pattern
the center y-coordinate is 15 Inches.
Note: When determining angles, 0° is at the 3 o’clock position and the
rotation goes counterclockwise.
KEYSTROKE DISPLAY
OO
0.
1. Enter the Center x-coordinate:
(cont’d)
KEYSTROKE DISPLAY
To Next Page
Loading...
