Keyword Information and Location
CentralRouters
This setting specifies a list of PakBus addresses for routers that are able
to work as Central Routers. By specifying a non-empty list for this
setting, the datalogger will be configured as a Branch Router meaning
that it will not be required to keep track of neighbours of any routers
except those in its own branch. Configured in this fashion, the
datalogger will ignore any neighbour lists received from addresses in
the central routers setting and will forward any messages that it
receives to the nearest default router if it does not have the destination
address for those messages in its routing table.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Advanced |
Central Routers
CommsMemAlloc
Replaces PakBusNodes. Controls the amount of memory allocated for
PakBus routing and communications in general. Increase the value of
this setting if you require more memory dedicated to communications.
Increase this value if the datalogger will be used for routing a large
number of PakBus nodes (>50). Increase this value if your datalogger is
dropping connections during short periods of high TCP/IP traffic. This
setting will effect the values reported in CommsMemFree.
l Numeric data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Advanced |
Communication Allocation
9. Tips and troubleshooting 139
To Next Page
Loading...
