COPYRIGHT
©
2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
1-15
CHAPTER 1 GENERAL DESCRIPITON
Mode Description
Timer Auto Clear Time Use it to set the time after which the touch panel
Settings returns to the Standard screen at the end of operation.
(0 to 9 min/2 min*)
Auto Energy Saver Time Use it to set the time after which energy save mode
starts. (0 min to 8 hr/30 min*)
Auto Power-Off Time Use it to set the time after which the power is turned off
when the copier is ready for copying or in energy save
mode. (0 to 24 hr/1 hr*)
Adjustment
/
Zoom Fine Adjustment Use it to make fine-adjustments if the original size and
Cleaning the copy size have a slight discrepancy in vertical and
horizontal reproduction ratios.
Range: ±1.0%
Unit: 0.1%
Exposure Recalibration Use it to correct the density used for the manual density
adjustment standard (center graduation).
Auto Gradation Use it to correct the hue of images. Operate on the touch
Adjustment panel; you need not press the Start key.
Text/Photo Priority Use it to adjust the slice level used to distinguish
between text and photo when the original type is set to
“text/printed photo” or “text/silver halide photo.”
Printer Gradation Use it to smooth out the gradations of color for printer
Adjustment output. (on*/off)
SWOP Emulation Use it to lower the density of halftone areas to simulate
Adjustment printed hues.
Feeder Cleaning Use it to clean the feeder by placing paper in the feeder.
(The paper will be circulated inside the feeder, thereby
removing dirt from the pickup roller assembly.)
Wire Cleaning Use it to clean the wires of charging assemblies.
Original Type Use it so that the output images from the controller
Selection for Printer match the types of originals used.
Table 1-402b
* : default.
To Next Page
Loading...
