Canon DC10 E - Page 102

DC10 E, DC20 E
DISASSEMBLING
41
<Note on Reassembling>
(1) Attach the LCD Sheet 1 to the position indicated in the figure below.
(2) Attach the parts ranging from the LCD Frame to the LCD PCB as shown in the figure below.
(3) Attach the LCD Sheet 2 to the position indicated in the figure below.
Fig. 38
Note on Reassembling (2)
Note on Reassembling (1) Note on Reassembling (3)
C
C
LCD Back Light Ass'y
LCD Back Light Ass'y
LCD BACK LIGHT FPC
LCD Shield Sheet
LCD Bottom Cover
LCD Bottom Cover
LCD Sheet 1
LCD Sheet 2
LCD Frame
Make it hit against
the end.
Push in
Push into the hole.
Adjust them.
LCD Frame
A
B
A
LCD Panel
GND Spring section
5. Attach the LCD PCB.
1. Push the LCD Panel into the GND Spring
section and then into the sections A and B.
3. With the four sections C aligned with the LCD
Back Light Ass'y, stick the LCD Shield Sheet.
6.Assemble the parts and solder (α) them.
2. Attach it to the LCD Bottom Cover.
4. Attach the LCD Back Light Ass'y.
LCD PCB
Align with the end
of the angle R.
Wrinkle and slippage not allowed. Wrinkle and slippage not allowed.
Align with the step difference.
Align with the sheet
metal of LCD Frame.
−1 mm
Attachment
reference
Attachment
reference :
−1 mm
Attachment
reference :
−1 mm
Attachment
reference :
−2 mm
Attachment
reference :
−1 mm
Attachment
reference :
−1 mm
Attachment
reference :
Solder α