Canon DC10 E - AF and IS Section Adjustments

DC10 E, DC20 E
SERVICE MODE / ADJUSTMENT
22
5-3 AF Section Adjustment
Note)
(1) The sections 5-3-2 : CZ automatic adjustment and 5-3-3 : Cam correction (AUTO) must be executed consecutively. If they are
performed independently, the sufficient performance cannot be obtained.
Also, when section 5-3-2 : CZ automatic adjustment is completed, execute section 5-3-3 : Cam correction (AUTO) must be
executed immediately without elapse of time. If section 5-3-3 : Cam correction (AUTO) is executed after elapse of time upon
completion of section 5-3-2 : CZ automatic adjustment, the sufficient performance cannot be obtained.
Preparation)
(1) For AF section Adjustment, use the product state.
(2) CZ adjustment and cam correction conditions (initial state)
Movie/Still : Movie
Shooting mode : Program AE
ZOOM : Telephoto-end
CZ adjustment chart : 2.4 ± 0.02 m from lens front
Chart luminance : 500 lux or more (High illuminance should be avoided at the wide-angle end.)
Digital Zoom : OFF
Auto slow shutter : OFF