Part
1:
General Information
8.Body
8-1
Custom
Functions:
No. Custom Function
C01: Film rewind mode
CO2:
Film leader position
C03: Film speed setting
C04: AE Lock and AF
COS:
Mirror lock & self-timer
C06: Flash sync timing
C07: AF-I lluminator
COS:
Partial metering and
FE lock linkage to
focusing point
C09: Shutter speed setting
during Av AE
or
flash use
C10: Focusing point flashing
C11: Eye-activated D-o-F:
I]
Eleven
Custom
Functions
are
provided.
The
desired
cus-
tom
functions
is
selected
by
setting
the
Command
Dial
to
"CF"
and
turning
the
Main
Dial.
The
custom
function
can
then
be
set
by
pressing
the
AE
lock
button.
Function
0:
Automatic silent rewind at the end of the roll.
1: Automatic high-speed rewind at the end of the roll.
0: Rewinds the film leader into the cartridge.
1:
Leaves the film leader outside the cartridge.
0:
Film speed set automatically by the DX code.
1:
Film speed set manually.
0:
Enables AF operation by pressing the shutter button
halfway and enables AE lock with the AE lock button.
1:
Enables AF operation by pressing the AE lock button and
enables AE lock by pressing the shutter button halfway.
2:
Enables AF operation by pressing the shutter button
halfway and enables the AE lock button to stop down the
aperture.
{When either 1 or 2 is set, FE lock with Speedlite 380 EX
does not function.)
0: Enables normal self-timer and remote control operations.
1:
Enables the shutter button (when pressed completely) to
lock up the mirror and release the shutter 2 sec. later.
(Mirror lockup is also possible with Remote Controller
RC-1
set for a 2-sec. delay.)
0:
Front-curtain synchronization.
1:
Rear-curtain synchronization (with the built-in flash or
Speedlite 380 EX.)
0:
Enables automatic emission of AF-llluminator.
1:
Disables AF-llluminator.
0:
Links partial metering and FE lock to the center.
1:
Links partial metering and FE lock to selected focusing
point. If focusing point is set for automatic selection,
partial metering and FE lock will be linked to the center.)
0: Sets shutter speed automatically.
1:
Sets shutter speed to 1/125 sec.
0:
Enables focusing point flashing.
1:
Disables focusing point flashing.
0:
Enabled. (Enabled for six seconds after focus is achieved
in
One-Shot AF mode.)
1:
Disabled.
1-14
To Next Page
Loading...
