Canon imagePRESS Lite C170 Series Service Guide
imagePRESS Lite C170 Series Service Guide March 2022
Revision 11 Page 53
Floor Structure:
• The floor on which this machine will be installed must have a floor load of
at least 81.9 lb/ft
2
(400 kg/m
2
). Even if the floor does not have this level of
floor load, the machine can be installed near a pillar or beam. Consult with
your building contractor before installing the machine.
• The weight of the machine will be primarily focused on the floor through
the adjuster and wheels. We recommend the use of a floor plate to
distribute the weight.
• We also recommend the use of a floor plate when installing the machine
on carpet or wood flooring. For information about floor plates, contact your
dealer.
• Do not install the machine on an unstable floor or platform.
Additional Space Requirements
• Minimum corridor width to navigate turns for the main unit and most
accessories is 85.5” (2,170 mm). Minimum corridor width to navigate turns
for the booklet trimmer 98.3” (2,498 mm).
• The machine should not be moved once it is in place.
Table 23 – Minimum Configuration Installation Space
Main Unit with Copy Tray-R2 attached
To Next Page
Loading...
