WebCAM user manual -4-
Chapter 2: Installation Procedure
Chapter 2: Installation Procedure
Before you start using WebCAM, you will need to set-up both the hardware and
software. The following is a flow chart on the installation procedure:
Fig.6. WebCAM installation flowchart
Connect WebCAM,
USB Camera and the Network cable
(Chapter 3)
Connect Network cable to ROUTER
/ HUB / xDSL modem
Install Utility (Chapter 4) and
MultiMonitor (Chapter 6)
Use Internet Explorer (>5.0) to
access WebCAM Web Manager
(Chapter 5).
WebCAM set-up completed
1
2
3
4
5
To Next Page
Loading...
